8
…2.3
Operating Page
2.3.3
Wash Function
Note.
Applicable only if Alarm 3 (
A3: Type
) is set to
Wash
in the
CONFIG. ALARMS
page – see Section 5.4.
Wash Function
Off
– Wash function off. Lower display line of
Operating Page
shows
WASH INHIBITED
.
On
– Wash function controlled automatically. Lower display line of
Operating Page
shows
WASH IN PROGRESS
.
Manual
– Enables wash function to be initiated manually – see below.
Caution.
Set
Wash Function
to
Off
before removing the sensor from the process.
See Section 3.1.
Probe Type
set to
pH
(for
either
sensor if dual input analyzer) – see Section 5.3.
See Section 4.1.
Probe Type
set to
Redox
or
ORP
(for
both
sensors in any combination if dual input analyzer)
– see Section 5.3.
Sensor calibration enabled (Section 5.3) – see Section 4.1.
Alter Sec. Code
not set to zero (Section 5.7) – see Section 5.1.
Alter Sec. Code
set to zero (Section 5.7) – see Section 5.2.
Wash Function
set to
Manual
– see below.
Wash Function
not set to
Manual
.
Press to Wash
(Manual Wash only)
Press
to Wash
and
Press
to Abort
are shown alternately on the lower display line.
Press the
key to initiate the wash cycle. The display returns to the top of
the
Operating Page
and the lower display line shows
WASH IN PROGRESS
until
the wash cycle is completed. The
Wash Function
selection resets to the one
that was set before
Manual
was selected.
Press the
key to abort the wash cycle. The display returns to the top of
the
Operating Page
.
VIEW SETPOINTS
SENSOR CAL.
Wash Function
-----
Manual
On
Off
-----
Press To Wash
Press To Abort
SENSOR CAL.
Security Code
CONFIG. DISPLAY
Press To Wash
MONITORING PH
WASH IN PROGRESS
MONITORING PH
…2
OPERATION
