AW T4 20 |
U N I V ER S A L 4 - W I R E , D UA L- I N P U T T R A N SM I T T ER | O I/AW T4 2 0 - EN R E V. B
21
6 Easy Setup
When the transmitter is started up for the first time, or when
Restore defaults
is selected from the
Configuration/Device
Setup/Initial Setup
menu (see page 38), the ‘Easy Setup’
prompt is displayed:
Press the key ( ) to start
Easy Setup
or press the key (
)
to cancel and exit to the main
Operator
page.
Press the key (
Edit
) to change the default value/setting to
the required value/selection. Press the key (
Next
) to accept
the default or revised value/selection and advance to the next
parameter.
Transmitter parameters that can be configured in this way are:
Language, Instrument Tag, Diagnostics View, Signals View,
Chart View, Alarm View, Analog OP View, Calibration Log,
Alarm Log, Audit Log, Diagnostics Log, Date Format
and
Date
& Time
. On completion of
Easy Setup
, the display returns to the
Easy Setup
start screen:
Press the key (
Select
) to revise/amend the settings just
made or press the key (
Exit
) to cancel and exit to the main
Operator page.
All transmitter parameters can be revised/changed at any time
by selecting
Enter Configuration
from any
Operator
or
View
page menu, followed by
Advanced
from the
Access Level
menu.
NOTICE
• If
Easy Setup
does not detect a key press within 5
minutes, the display changes automatically to the main
Operator
page.
• Refer to page 25 for details of menu navigation and
parameter selection/adjustment.
7 Calibration and sensor setup
CAUTION
Do not attempt to setup the transmitter unless both the
sensor and transmitter are fully installed and ready for
operation.
NOTICE
• The menu structure, general operation and menu
descriptions are detailed on page 36.
• Refer to page 25 for details of menu navigation and
parameter selection/adjustment.
Ensure all electrical connections have been made correctly and
switch on the power to the transmitter. If the sensor is being
commissioned for the first time, sensor calibration and set-up
is recommended for best results.
Refer to the following pages for calibration and setup
procedures:
• 2-electrode conductivity sensors – page <?>
• 4-electrode conductivity sensors – page 57
• pH/Redox/ORP sensors – page 59
• Turbidity/Suspended solids – page 70
• Dissolved oxygen sensors – page 81
AWT420
03-09-2019
08:14:45
New TX
Detected
Start Easy
Setup ?
Menu
Easy Setup
Exit
Select
