ABB AWIN GW100, User Manual

Page: 59 / 68

GOOD TO KNOW HOW TO C HANGE D EVIC E TAG NA ME?
3BNP1029 12 C 55
handheld, ABB FIM or AWIN WIrelessHART Gateways Configurator to change tag name. Re-
fer to their user manual for details.
5. Afterwards, go to Modbus Configuration page, select Manual mode and import the Mod-
bus map saved in Step1.
Note: The device’s Long Tag can be changed at any time via the IO Schedule.
9.4 How to Change Device Tag Name?
The long tag of a device can be changed by using HART handheld, ABB Asset Vision Basic,
ABB FIM and AWIN WirelessHART Gateways Configurator.
Refer to the user manual of these products for detail procedure. For using AWIN Gateways
WirelessHART Configurator refer to document number 3BNP102911.
9.5 How to Use Remote Antenna?
In general, for non- hazardous area deployments, a standard 2.4GHz antenna can be used. Re-
fer to the antenna user manual for details.
As an example, see the following illustration for remote antenna connectivity with AWIN
GW100.
Figure 33. Example of remote antenna assembly.
9.6 How is Battery Life Cached in the Gateway?
The battery life of a device reported in the gateway webpage and on Modbus connection is
populated as follows:
- Gateway checks for response to Command 778.
- Gateway checks for device variable code 243 (“battery life”) in Command 9.
- Gateway checks for variable units code of 53 (“days”) in Command 3.
If a valid message is received, then battery life is set.
Antenna
AWIN GW100
Gateway
Antenna cable
Antenna barrier
Adapter cable