25
EntelliGuard R Circuit Breaker Retrofill AKD-6 Installation Manual DEH-41548 07/15
Installing Door Interlock System (Breaker)
P/N 10108779G1
Door Interlock Kit
Tools required: Flat screw driver, E-clip mounting tool
The door interlock system prevents opening of the breaker compartment door when the breaker is in the
racked-in position and connected state.
shows the components that make up the AKD-6 retrofill door
interlocking assembly.
Figure 11. AKD-6—Door Interlocking Components
The sequence of assembly steps of the door interlock is as follows:
1.
Unpack the door interlock kit. Each kit consists of a torsion spring, two E-clips and a breaker side-door
interlock bracket.
2.
Place the torsion spring on the pin as shown in the exploded view below and anchor it by placing one end
of the pin into the hole provided inside the side-sheet of the retrofill.
3.
Mount the door interlock bracket on the same pin via the hole provided on the bracket. Also, it must be
ensured that the slot of the door interlock bracket is mounted on the second pin, placed on the front as shown
in
4.
Mount the free end of the torsion spring on the bracket as shown
5.
Insert the E-clips mentioned in Step 1 to complete the assembly.
