ABB ACSM1 Series, Firmware Manual

Page: 173 / 334

Parameters and firmware blocks
173
93.11 ENC2 PULSE NR FW block: PULSE ENC CONF (see above)
Defines the pulse number per revolution for encoder 2.
0…65535 Pulses per revolution for encoder 2.
93.12 ENC2 TYPE FW block: PULSE ENC CONF (see above)
Selects the type of encoder 2. For selections, see parameter 93.02 ENC1 TYPE .
93.13 ENC2 SP CALCMODE FW block: PULSE ENC CONF (see above)
Selects the speed calculation mode for encoder 2.
For selections, see parameter
93.03 ENC1 SP CALCMODE .
93.14 ENC2 POS EST ENA FW block: PULSE ENC CONF (see above)
Selects whether measured and estimated position is used with encoder 2.
For selections, see parameter
93.04 ENC1 POS EST ENA .
93.15 ENC2 SP EST ENA FW block: PULSE ENC CONF (see above)
Selects whether calculated or estimated speed is used with encoder 2.
For selections, see parameter
93.05 ENC1 SP EST ENA .
93.16 ENC2 OSC LIM FW block: PULSE ENC CONF (see above)
Selects the maximum pulse frequency for the changing of the direction of rotation (used with
encoder 2).
For selections, see parameter
93.06 ENC1 OSC LIM .
93.21 EMUL PULSE NR FW block: ENCODER (page 161 )
Defines the number of TTL/HTL pulses per revolution used in encoder emulation.
Encoder emulation is enabled by parameter
90.03 EMUL MODE SEL .
0…65535 TTL pulses used in encoder emulation.
93.22 EMUL POS REF FW block: ENCODER (page 161 )
Selects the source for the position value used in encoder emulation when parameter 90.03 EMUL
MODE SEL is set to (1) FEN-01 SWREF , (4) FEN-11 SWREF , (7) FEN-21 SWREF or (10) FEN-31
SWREF . See parameter group 90 ENC MODULE SEL .
The source can be any actual or reference position value (except 1.09 ENCODER 1 POS and 1.11
ENCODER 2 POS ).
Value pointer: Group and index