Quick installation and start-up guide – ACSM1-204 11
Start-up
Safety
The start-up may only be carried out by a qualified electrician.
The safety instructions must be followed during the start-up procedure. See the
safety instructions on the first pages of the appropriate hardware manual.
Check the installation.
I/O connections
Check that the I/O connections have been made as shown in
Default I/O connection diagram
Power up
By default, the regen supply module starts modulating when the power is switched on
unless prevented by I/O.
Switch the power on.
When the regen supply module is modulating, the lower
segments in the 7-segment display are lit in a clockwise-
rotating sequence.
7-segment display:
Network identification
The regen supply module fetches the network data
automatically in the first start-up after the power-up. The
automatic network identification takes 5…10 ms.
In a unit with an externally powered JCU, the automatic
network identification also takes place in the first start-up after
the PU has been switched off.
Fieldbus control
See the
Firmware Manual
.
->
ACSM1-204 Quick Quide.book Page 11 Tuesday, October 6, 2009 11:02 AM
