ABB ACS880-M04, Hardware Manual

Page: 118 / 195

118 Technical data
Supply cable fuses
Fuses for short circuit protection of the supply cable are listed below. The fuses also
protect the adjoining equipment of the drive in case of a short circuit.
Check that the operating time of the fuse is below 0.5 seconds. The operating time
depends on the supply network impedance and the cross-sectional area and length
of the supply cable. See also chapter
Planning the electrical installation on page 55 .
Note: Fuses with a higher current rating must not be used.
Drive type
ACS880-M04 Input
current
(A) IEC fuse UL fuse Cross-sectional
area of cable
Rated
current
(A) Volt-
age
(V) Class Rated
current
(A)
Volt-
age
(V) UL
class mm
2
AWG
-03A0-2, -03A0-5 4.0* 6 500 gG 6 600 T 1.5…4 16…12
-03A6-2, -03A6-5 6.0* 6 500 gG 6 600 T 1.5…4 16…12
-04A8-2, -04A8-5 7.0* 10 500 gG 10 600 T 1.5…4 16…12
-06A0-2, -06A0-5 9.0* 10 500 gG 10 600 T 1.5…4 16…12
-08A0-2, -08A0-5 11* 16 500 gG 15 600 T 1.5…4 16…12
-010A-2, -010A-5 13* 16 500 gG 15 600 T 1.5…10 16…8
-014A-2, -014A-5 18* 20 500 gG 20 600 T 1.5… 0 16…8
-018A-2, -018A-5 23* 25 500 gG 25 600 T 1.5…10 16…8
-025A-2, -025A-5 20 25 500 gG 25 600 T 6…35 9…2
-030A-2, -030A-5 26 32 500 gG 35 600 T 6…35 9…2
-035A-2, -035A-5 30 40 500 gG 35 600 T 6…35 9…2
-044A-2, -044A-5 36 50 500 gG 45 600 T 6…35 9…2
-050A-2, -050A-5 42 50 500 gG 50 600 T 10…70 6…2/0
-061A-2, -061A-5 55 63 500 gG 70 600 T 10…70 6…2/0
-078A-2, -078A-5 65 80 500 gG 80 600 T 10…70 6…2/0
-094A-2, -094A-5 82 100 500 gG 100 600 T 10…70 6…2/0
*Without mains choke
AWG cable sizing is based on NEC Table 310-16 for copper wires, 75 °C (167 °F) wire insulation at 40 °C
(104 °F) surrounding air temperature. Not more than three current-carrying conductors in raceway or cable
or earth (directly burried). For other conditions, dimension the cables according to local safety regulations,
appropriate input voltage and the load current of the drive.