ABB ACS880-14, Hardware Manual

Page: 163 / 248

5. Undo the mounting screws of the fan. The finger guard of the fan is attached by the
same screws and is removed at the same time. Keep the finger guard for reuse
6. Install the new fan in reverse order. Make sure that the arrow in the fan points up.
5
2
3
4
Replacing the standard drive module
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
Handle the drive module carefully:
• Use safety shoes with a metal toe cap to prevent foot injury.
• Lift the drive module only by the lifting lugs.
• Make sure that the module does not topple over when you move it on the floor: To open
the support legs, press each leg a little down and turn it aside (1, 2). Whenever possible
secure the module also with chains.
• Do not tilt the drive module. It is heavy and its center of gravity is high. The module
overturns from a sideways tilt of 5 degrees. Do not leave the module unattended on a
sloping floor
Maintenance 163