ABB ACS580-01 Series, Quick Installation And Start-Up Manual

Page: 11 / 36

EN – R6…R9 Quick installation guide 11
R0-
R4
R6-
R9
R6-
R9
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
RU
SV
TR
ZH ZH
EN – R6…R9 Quick installation guide
This guide briefly describes how to install the drive for IEC use. For complete
information on installation, see
ACS580-01 (0.75 to 250 kW, 1.0 to 350 hp) hardware
manual (3AXD50000044794 [English]). For start-up instructions, see chapter EN –
Quick start-up guide on page 23 .
To read a manual, go to www.abb.com/drives/documents and search for the
document number.
Obey the safety instructions
Check if capacitors need to be reformed
The capacitors must be reformed if the drive has not been powered (either in storage
or unused) for a year or more.
You can determine the manufacturing time from the serial number, which you find on
the type designation label attached to the drive. The serial number is of format
MYYWWRXXXX. YY and WW tell the manufacturing year and week as follows:
YY: 17, 18, 19, … for 2017, 2018, 2019,
…
WW: 01, 02, 03, … for week 1, week 2, week 3,
…
WARNING! Obey these instructions. If you ignore them, injury or death, or
damage to the equipment can occur:
• If you are not a qualified electrical professional, do not do electrical installation
work.
• Do not work on the drive, motor cable or motor when main power is applied. If
the drive is already connected to the input power, wait for 5 minutes after
disconnecting the input power.
• Do not work on the control cables when power is applied to the drive or to the
external control circuits.
• Use the lifting eyes of the drive when you lift the drive. Do not tilt the drive. The
drive is heavy and its center of gravity is high. An overturning drive can cause
physical injury.
• Make sure that debris from drilling, cutting and grinding does not enter the drive
when installing.
• Make sure that the floor below the drive and the wall where the drive is installed
are non-flammable.