328 Parameters
Selects the type and scaling of actual value 1 transmitted to
the fieldbus network through fieldbus adapter A. The scaling
of the value is defined by parameters
…
,
depending on which actual value type is selected by this
parameter.
Speed or frequency Type and scaling is chosen automatically according to the
currently active operation mode as follows:
0
Transparent
No scaling is applied.
1
General
Generic reference without a specific unit.
2
Torque
The scaling is defined by parameter
.
3
Speed
The scaling is defined by parameter
.
4
Frequency
The scaling is defined by parameter
. 5
Selects the type and scaling of actual value 2 transmitted to
the fieldbus network through fieldbus adapter A. The scaling
of the value is defined by parameters
…
,
depending on which actual value type is selected by this
parameter.
Speed or frequency Type and scaling is chosen automatically according to the
currently active operation mode as follows:
0
Transparent
No scaling is applied.
1
General
Generic reference without a specific unit.
2
Torque
is sent as actual value 2. The scaling
is defined by parameter
3
Speed
The scaling is defined by parameter
.
4
Frequency
The scaling is defined by parameter
. 5
Selects the source of the fieldbus status word when
parameter
is set to
.
Not selected
No source selected.
-
Source selection (see
). -
is set to
, this parameter selects the source of actual value
1 transmitted to the fieldbus network through fieldbus adapter
A.
Not selected
No source selected.
-
Source selection (see
). -
No.
Name/Value
Description
Def/FbEq16
Operation mode
(see par.
)
Actual value 1 type
Speed control
Torque control
Frequency control
Operation mode
(see par.
)
Actual value 2 type
Speed control
Torque control
Frequency control
Summary of Contents for ACS560
