ABB ACS350 Series, User Manual

Page: 45 / 314

Start-up, control with I/O and ID Run
45
Start-up, control with I/O and ID Run
What this chapter contains
The chapter instructs how to:
• perform the start-up
• start, stop, change the direction of rotation and adjust the speed of the motor
through the I/O interface
• perform an Identification Run for the drive.
Using the control panel to do these tasks is explained briefly in this chapter. For
details on how to use the control panel, refer to chapter
Control panels starting on
page 57 .
How to start up the drive
How you start up the drive depends on the control panel you have, if any.
• If you have no control panel , follow the instructions given in section How to start
up the drive without a control panel on page 45 .
• If you have a Basic Control Panel , follow the instructions given in section How
to perform the limited start-up on page 46 .
• If you have an Assistant Control Panel , you can either run the Start-up
Assistant (see section How to perform the guided start-up on page 51 ) or perform
a limited start-up (see section How to perform the limited start-up on page 46 ).
The Start-up Assistant, which is included in the Assistant Control Panel only,
guides you through all essential settings to be done. In the limited start-up, the
drive gives no guidance; you go through the very basic settings by following the
instructions given in the manual.
How to start up the drive without a control panel
SAFETY
The start-up may only be carried out by a qualified electrician.
The safety instructions given in chapter
Safety must be followed during the start-up
procedure.
The drive will start up automatically at power up if the external run command is on.
Check the installation. See the checklist in chapter Installation checklist .
Check that the starting of the motor does not cause any danger.
De-couple the driven machine if there is a risk of damage in case of incorrect direction of
rotation.