ABB ACS280, Firmware Manual, Page: 184 / 430

184 Parameters
30.17 Maximum current
Defines the maximum allowed motor current.
The system sets the default value to 90% of the rated
current. If required, you can increase the parameter
value by 10%.
Note: The maximum current range and default value
depends on the drive type.
3.89 A
0.00…4.32 A Maximum motor current. 1 = 1 A
30.18 Torq lim sel
Selects a source that switches between two different
predefined minimum torque limit sets.
0 = minimum torque limit defined by
30.19 and
maximum torque limit defined by
30.20
are active
1 = minimum torque limit selected by
30.21
and
maximum torque limit defined by 30.22 are active
The user can define two sets of torque limits, and
switch between the sets using a binary source such as
a digital input.
The first set of limits is defined by parameters
30.19
and 30.20 . The second set has selector parameters
for both the minimum (
30.21
) and maximum (
30.22
)
limits that allows the use of a selectable analog
source (such as an analog input).
Note: In addition to the user-defined limits, torque
may be limited for other reasons (such as power
limitation). Refer to the block diagram on page
373
.
Torque limit
set 1
Torque limit set 1 0 (minimum torque limit defined by
30.19
and
maximum torque limit defined by
30.20
are active).
0
Torque limit set 2 1 (minimum torque limit selected by
30.21
and
maximum torque limit defined by
30.22
are active).
1
DI1 Digital input DI1 (
10.02 DI delayed status
, bit 0). 2
DI2 Digital input DI2 (
10.02 DI delayed status
, bit 1). 3
DI3 Digital input DI3 (
10.02 DI delayed status
, bit 2). 4
DI4 Digital input DI4 (
10.02 DI delayed status
, bit 3). 5
EFB Only for the DCU profile. DCU control word bit 15
received through the embedded fieldbus interface.
11
No. Name/Value Description Default
FbEq 16
30.21
User-defined
minimum torque
limit
0
AI1
AI2
PID
30.23
Other
0
AI1
AI2
PID
30.24
Other
30.19
30.22
30.18
0
1
30.20
30.18
0
1
User-defined
maximum torque
limit