ABB ACS280, Firmware Manual, Page: 154 / 430

154 Parameters
22.73 Motor potentiometer
up source
Selects the source of motor potentiometer up signal.
0 = No change
1 = Increase motor potentiometer value. (If both the
up and down sources are on, the potentiometer value
will not change.)
not used
Not used 0. 0
Used 1. 1
DI1 Digital input DI1 (
10.02 DI delayed status
, bit 0). 2
DI2 Digital input DI2 (
10.02 DI delayed status
, bit 1). 3
DI3 Digital input DI3 (
10.02 DI delayed status
, bit 2). 4
DI4 Digital input DI4 (
10.02 DI delayed status
, bit 3). 5
Supervision 1 Bit 0 of
32.01 Supervision status
. 24
Supervision 2 Bit 1 of
32.01 Supervision status
. 25
Supervision 3 Bit 2 of
32.01 Supervision status
. 26
Supervision 4 Bit 3 of
32.01 Supervision status
. 27
Supervision 5 Bit 4 of
32.01 Supervision status
. 28
Supervision 6 Bit 5 of
32.01 Supervision status
. 29
Other [bit]
Source selection (see
Terms and abbreviations
). -
22.74 Motor potentiometer
down source
Selects the source of motor potentiometer down
signal.
0 = No change
1 = Decrease motor potentiometer value. (If both the
up and down sources are on, the potentiometer value
will not change.)
For the selections, see parameter
22.73 .
not used
22.75 Motor potentiometer
ramp time
Defines the change rate of the motor potentiometer.
This parameter specifies the time required for the
motor potentiometer to change from minimum
(parameter 22.76 ) to maximum (parameter 22.77 ). The
same change rate applies in both directions.
40.0 s
0.0…3600.0 s Motor potentiometer change time. 1 = 1 s
22.76 Motor potentiometer
min value
Defines the minimum value of the motor
potentiometer.
Note: If vector control mode is used, the value of this
parameter must be changed.
-50.00
-32768.00… 32767.00 Motor potentiometer minimum. 1 = 1
22.77 Motor potentiometer
max value
Defines the maximum value of the motor
potentiometer.
Note: If vector control mode is used, the value of this
parameter must be changed.
50.00
-32768.00… 32767.00 Motor potentiometer maximum. 1 = 1
22.80 Motor potentiometer
ref act
Shows the output of the motor potentiometer
function. (The motor potentiometer is configured
using parameters
22.71
…
22.74
.)
This parameter is read-only.
-
-32768.00… 32767.00 Value of motor potentiometer. 1 = 1
No. Name/Value Description Default
FbEq 16