ABB ACS-AP-x, User Manual

Page: 41 / 66

Functions in the main Menu 41
• Reset to defaults: You can reset Settings
into their default values.
• Erase fault log: This functionality is
available in a future release.
• Reset Home view layout: Default Home
view settings are restored.
• Reset all parameters: This functionality
is available in a future release.
• Show in lists: Show or hide the numeric IDs of:
• parameters and groups
• option list items
• bits
• devices in Options > Select drive .
• Pass code: Pass codes can be entered into this parameter to activate further
access levels (for example additional parameters).
Primary settings
The Primary settings menu has the following
sub-menus:
• Macro: Setup drive control and reference
source by selecting from a set of predefined
wiring configurations.
• Motor: Adjust motor-related settings, such as
control mode, nominal values, ID run or
thermal protection. Note that the settings that
are visible depend on other selections, for
example vector or scalar control mode, used motor type or selected start mode.
• Start, stop, reference: Set up start/stop commands, reference, and related
features, such as constant speeds or run permissions.
• Ramps: Set up acceleration and deceleration settings.
• Limits: Set the allowed operating range. This function is intended to protect the
motor, connected hardware and mechanics. The drive stays within these limits, no
matter what reference value it gets.
• PID: Set up the settings and actual values for the process PID controller. PID is
only used in remote control.
• Fieldbus: To make the protocol configurations easier.
• Advanced options: Contains settings for advanced functions, such as triggering
or resetting faults through I/O, or switching between entire set of settings.