ABB ACQ800 Series, Hardware Manual

Page: 122 / 140

122 ACQ800-37 Hardware Manual
Technical data
CE marking
A CE mark is attached to the drive to verify that the unit follows the provisions of the European Low
Voltage, and EMC Directives. The CE marking also verifies that the drive, in regard to its safety
functions (such as Safe torque off), conforms with the Machinery Directive as a safety component.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to standards
EN 60204-1 and EN 61800-5-1.
Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical equipment used
within the European Union. The EMC product standard (EN 61800-3:2004) covers requirements stated
for drives. See section
Compliance with EN 61800-3:2004 on page 125 .
Compliance with the European Machinery directive
The drive is an electronic product which is covered by the European Low Voltage Directive. However,
the drive can be equipped with the Safe torque off function and other safety functions for machinery
which, as safety components, are in the scope of the Machinery Directive. These functions of the drive
comply with European harmonized standards such as EN 61800-5-2. The declaration of conformity for
each function is in the appropriate function-specific manual.