ABB ABB-free home, System Manual

Page: 26 / 76

04 Commissioning ABB-free@home
®
26
│ System Manual
Identification
If, after positioning on the floor plan, there are several
possible devices in the pop-up window for selection, the
device which switches the desired function must now be
selected.
Identification via serial number (Fig. 20)
» Compare the short 3-digit number (identification
number) of the identification label on your device plan,
or on the device, with the numbers in the list and in
this way identify the device you are searching for and,
if necessary, also the channel.
Identification via local operation (Fig. 21)
Go to the device that is to be linked with the selected
application. Actuate the device:
» Actuator: Press the "Ident" button on the device.
» Sensor: Press the rocker.
» Movement detector: Cover the lens with the hand.
» The associated device is selected automatically. In
case an actuator has several channels you now need
to select the correct channel.
Identification via switching
(only suitable for actuators, Fig. 22)
» Select a device and a channel from the list.
» Press the button in the detailed view of the device.
» The connected load is switched.
» Continue until you have found the device you are
looking for.
Specifying a name (Fig. 23)
» When the device has been found, enter a name that is
easy to understand and under which the application is
to be displayed later (e.g. "Ceiling light").
» Press the tick at the bottom right to take over the
entry.