bdi
Access
JTAG interface library, BDI1000 (ARM7/9/9E)
Installation Manual
5
© Copyright 1992-2008 by ABATRON AG
V 1.02
TARGET A Connector Signals
The BDI1000 works also with targets which have no dedicated TRST pin. For this kind of targets, the
BDI cannot force the target to debug mode immediately after reset. The target always begins execu-
tion of application code until the BDI has finished programming the Debug Control Register.
Pin
Name
Describtion
1
reserved
This pin is currently not used.
2
TRST
JTAG Test Reset
This open-drain / push-pull output of the BDI1000 resets the JTAG TAP controller on the
target. Default driver type is open-drain. With a special init list entry it can be changed to
push-pull (see online help).
3+5
GND
System Ground
4
TCK
JTAG Test Clock
This output of the BDI1000 connects to the target TCK line.
6
TMS
JTAG Test Mode Select
This output of the BDI1000 connects to the target TMS line.
7
RESET
This open collector output of the BDI1000 is used to reset the target system.
8
TDI
JTAG Test Data In
This output of the BDI1000 connects to the target TDI line.
9
Vcc Target
This input to the BDI1000 is used to detect if the target is powered up.
10
TDO
JTAG Test Data Out
This input to the BDI1000 connects to the target TDO line.
