AAVIX AGT3420, Owner'S Manual

Page: 10 / 20

11
Chute Deflector Adjustment
1. Loosen the locking knob and adjust
the chute deflector to a suitable height.
The machine offers different positions
(0~60
°
). Re-tighten the locking knob.
(Fig.9).
Fig.9
WARNING! Ensure switch off the
motor first, then disconnect the plug
from the power supply, before
adjusting the discharge chute.
Operation
NOTE: Before using this machine,
make sure that the power source you
will use compiles with the
specifications detailed in this manual.
Before inserting the plug into the
socket, verify that the snow thrower’s
auger and rubber plates are firmly
secured, and that the rubber plates are
facing the correct direction. Perform a
test run to ensure that the rotor turns
freely.
Before connecting the snow thrower
with the electric power supply, make
sure that the mains supply voltage is
120V.
Securing the Extension Cord
To prevent the appliance cord from
disconnecting from the extension cord
during operation, make a knot with
the two cords as shown. (Fig.10)
Fig.10
Powering ON/OFF
WARNING! The auger starts
rotating immediately after the snow
thrower is switched on. Keep hands
and feet away from the auger.
1. Press the safety push-button.
2. Squeeze the switch bar. (Fig.11)
Fig.11
3. Once the snow thrower starts,
release the safety push-button and
proceed with operation.
4. To power OFF, release the switch
bar.
WARNING! Lift the front of the
machine and disconnect the plug from
the power supply when transporting