Using the front panel or remote control, you can change many settings of the phono stage.
Using the remote, you press the “Menu” button
F
to enter or exit the menu.
Using the front panel, you press and hold the navigation button
4
for 3 seconds.
When you enter the menu, the loading resistor setting will be shown on the display. The top line of the display shows the current option (“Preamp gain” when you enter the
menu), and the bottom line shows the current setting.
Using the remote, you can cycle through the options using the INPUT +
C
and INPUT -
D
buttons.
Using the front panel, press the navigation button
4
to cycle through the options.
Use the VOLUME UP
A
and VOLUME DOWN
B
buttons of the remote, the up and down front panel buttons (
a
/
b
) to change the settings.
Once in the menu, using the remote, you can cycle through all options in the order shown in the diagram below.
Using the front panel, the phono stage will return to normal operation once you have cycled through all the options.
MENU FUNCTIONS
7
SETTINGS FOR INDIVIDUAL INPUTS
DISPLAY SHOWS
Rin (phono input)
Using this function, you can set the loading resistor on the phono input. The range is 50 ohms to 10 kOhms.”
SETTINGS COMMON TO ALL INPUTS
Display brightness
You can change the display brightness in four steps: 10, 40, 70 and 100%
Display dim
Using this setting, you can set the display to switch off automatically after 1-5 seconds. The standard setting is off.
When the display is off, a single dim LED will be lit in the lower right corner.
Software version
This menu option shows the current firmware version of the phono stage.
