4
1
DISPLAY
During normal operation, the display shows “Aavik”.
When changing settings (see “MENU FUNCTIONS”
page 6), the display will show the setting being
changed.
2
STANDBY BUTTON
Press the standby button
2
to place the amplifier
in standby mode, or to switch on the amplifier from
standby mode. When the amplifier is in standby mode,
the only light showing on the amplifier will be a dim
LED light in the lower left corner. When you switch on
the amplifier, the outputs will be muted, and a line will
illuminate at the bottom of the displays, starting in
the lower left corner.
During the start-up cycle, the circuits of the amp will
stabilize. When using trigger cables between the pow-
er amp and a preamp, the power amp will be switched
on and off together with the preamp.
Note:
When using the power amp without a trigger
cable, remember to switch on the preamp before
switching on the power amp, and switch off the power
amp before switching off the preamp.
3
MUTE
When you press the mute button briefly, it will mute
the speaker outputs of the amplifier. The display will
show ”Mute” instead of the the standard “Aavik”.
4
MENU BUTTON
The menu button is used for accessing the menu. See
”MENU FUNCTIONS” page 6.
FACTORY RESET
You can reset all settings back to factory defaults.
This will erase gain settings and display settings. To
do this, proceed as follows:
1.
Switch off the amplifier at the main power
switch
7
2.
Wait 30 seconds
3.
Press and hold the three front panel
buttons
2
,
3
, and
4
4.
Switch on the main power using
7
, while still
holding the front panel buttons
5.
All LED indicators on the front panel will switch
on and stay on
6.
After approximately 8 seconds the LED indica-
tors will switch off again
7.
Release the front panel buttons, and switch off
the amplifier using the main power switch
7
FRONT PANEL FUNCTIONS
