MENU FUNCTIONS
SETTINGS FOR INDIVIDUAL INPUTS
DISPLAY SHOWS
DAC mode
You can switch the DAC between four settings. The default setting is “Upsampled, Slow”. You can switch upsampling on and off,
and switch between a slow (soft high-frequency roll-off) and a fast (steep high-frequency roll-off) filter.
Which setting provides the best performance, depends on the signal source connected to the input.
SETTINGS COMMON TO ALL INPUTS
Display brightness
You can change the display brightness in four steps: 10, 40, 70 and 100%
Display dim
Using this setting, you can set the display to switch off automatically after 1-5 seconds. The standard setting is off.
When the display is off, a single dim LED will be lit in the lower right corner.
Software version
This menu option shows the current firmware version of the DAC.
7
Using the front panel or remote control, you can change many settings of the DAC.
Using the remote, you press the “Menu” button
F
to enter or exit the menu.
Using the front panel, you press and hold the navigation button
4
for 3 seconds.
When you enter the menu, the DAC mode of the current input will be shown on the display. The top line of the display shows the current option (“DAC mode” when you enter the
menu), and the bottom line shows the current setting.
Using the remote, you can cycle through the options using the INPUT +
C
and INPUT -
D
buttons.
Using the front panel, press the navigation button
4
to cycle through the options.
Use the UP
A
and DOWN
B
buttons of the remote, or the up and down front panel buttons (
a
/
b
).
Once in the menu, using the remote, you can cycle through all options in the order shown in the diagram below.
Using the front panel, the DAC will return to normal operation once you have cycled through all the options.
