Integrated Access Controller –
Installation manual
AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
All rights reserved.
13
6.4 Adding a single card with a PIN code
After entering the programming mode enter the code
34
, then:
•
Enter the user ID from the list
•
Close the cards one of the other to the reader
•
Enter the PIN
-
> enter the PIN again
After you read the card and enter your PIN, the controller will generate a single
beep and automatically exits the programming mode.
6.5 Adding a group of users with PIN codes
After entering the programming mode enter the code
35
, then:
•
Enter the ID of the first user of the package
•
Enter the PIN
-
> enter the PIN again
•
Repeat the operation to enter PIN codes for next users
After each added user controller will generate a single beep. PIN codes entered
will be added to the next automatically generated ID numbers.
•
after loading press #
6.6 Adding a single user with a PIN code
After entering the programming mode enter the code
36
, then:
•
Enter the user ID from the list
•
Enter the PIN
-
> enter the PIN again
After a user added the controller generates a single beep and automatically exits
the programming mode.
7.1 Deleting a single user with a card or PIN
After entering the programming mode enter the code
37
, then:
•
Enter the user ID from the list
or
•
Close deleting card to the reader
After you read the card controller will generate a single beep and automatically
exits the programming mode.
7.1 Removal of all users
After entering the programming mode enter code
38
.
This process can take more than 10 seconds. Then the controller will generate a
single beep and automatically exits the programming mode.
8.1 Administrator PIN code
-
used to enter the programming mode
After entering the programming mode enter the code
41
, then:
•
Enter the PIN
-
> enter the PIN again
After adding a new administrator PIN code controller will generate a single beep
and automatically exits the programming mode.
NOTE: The default master code 000000 is mandatory to change after the
first entry into this mode on your own code using the command 41.
Leaving the default code allows third parties to enter into this mode and
operations, e.g. adding his own card. If you do not know the master
code reset can be performed from within the program KaDe
-
Controller
setup/Context menu/ Initialize Controller. The new password should be
download to all controllers.
8.2 PIN code security
After entering the programming mode enter the code
42
, then:
•
Enter the PIN
-
> enter the PIN again
After adding a PIN controller generates a single beep and automatically exits the
programming mode. This code can be used in the event of a forced entry
-
the
doors are unlocked mode and alarm signal is sent to the on
-
line monitoring at
the operator station.
