14 Model 6731i IP Phone Installation Guide
Installation and Setup
Install on the Wall
The 6731i IP phone has two pre-drilled wall mounting holes on the back of
the phone.
1. Using the provided wall mount drilling template, locate and mark the
position for the mounting screws on the wall. Depending on the wall
type, you may need to use wall anchors. Both the screws and wall
anchors are included with your phone.
2. Place the wall mount holes on the phone over the screw heads on the
wall and pull down to lock the phone in.
Note: You may wish to purchase a short Ethernet cable from a local supplier for a wall
installation. Also, if 802.3af compliant in-line power is not provided on your
network, and you are installing the
6731i
on a wall using a PoE in-line power
injector, you may also wish to use an equivalent flat Ethernet cable rather
than the one provided.
3. In the handset cradle, there is a small clip that sits flush with the cradle
surface. Using a small flathead screwdriver, pull the clip up and remove
it from the phone.
4. With the arms on the clip facing you and the flat side of the clip towards
the phone, turn the clip 180 degrees and reinsert it back into the clip
cavity in the phone’s cradle.
Wall Mount Holes
