Aastra BLUESTAR 8000I, Pbx-Mode Administrator Manual

Page: 80 / 143

41-001390-00 Rev 02 – 12.2011
5-1
Chapter 5
Advanced Operational Features
The BluStar 8000i has specific advanced operational features that you can configure. This chapter describes each feature
and provides procedures for configuring a BluStar 8000i to use these features.
Advanced Operational Features
This section provides information about the following advanced features on the
BluStar
8000i
:
• Update Caller ID During a Call
• MAC Address in REGISTER Messages
• SIP Message Sequence for Blind Transfer
• Removing UserAgent and Server SIP Headers
• Blacklist Duration
• Whitelist Proxy
• XML SIP Notify Events
• Configurable DNS Queries
• Ignore Out of Sequence Errors
• Switching Between Early Media and Local Ringing
• Configurable “Allow” and “Allow-Event” Optional Headers
• Configurable SIP P-Asserted Identity (PAI)
• Configurable Compact SIP Header
Update Caller ID During a Call
It is possible for a proxy or call server to update the caller ID information that displays on the BluStar 8000i during a call, by
modifying the SIP Contact header in the re-INVITE message. The BluStar 8000i displays the updated name and number
information contained within the Contact header. The “
sip update callerid ” parameter allows the system administrator to
enable or disable this feature.
Configuring Update Caller ID During a Call
Use the following procedure to configure the update caller ID feature during a call.
Configuration Files
For the specific parameter(s) you can set in the configuration files, see Appendix A, the section, Update Caller ID Setting
on page A-43 .