15
Aastra 610d, 620d, 630d
Aastra 610d, 620d , 630d Quick Reference Guide
Connecting the charging unit
Aastra 610d, 620d:
This handset can be used without
any changes to the charger cradle.
Aastra 630d
: To use this handset, you must remove the
two lateral guides in the charger cradle. They are easy to
lift on the inside edge using a fingernail or a paper clip.
The plastic guides can also be removed, by pushing a
suitable screwdriver into the slits on the bottom of the
charger.
Connect the plug-in power supply to the charger cradle
and place the connection cable through the cable guide.
Place the charger cradle on a non-slip surface. Change
the plug of the power supply unit if necessary.
Power Supply / Power unit
The power supply unit is designed for 100V to 240V AC
(50-60 Hz). It is supplied with four change adapters
enabling virtually worldwide use. Where necessary,
connect the plug normally used in your country to the
power supply unit. There are two versions of the plug-in
power supply unit that are connected slightly differently:
Version 1
: Set the switch on the power supply unit to
OPEN and push out the existing plug upwards.
Then insert the new plug required into the power supply
unit and lock it with the switch (LOCK).
Version 2
: Remove any existing plug by pressing OPEN.
Then insert the required new plug into the power
supply unit at a slight angle with the label TOP upwards.
Press downwards until it snaps into place
