A
ASTRA
6700
I
SIP T
ERMINALS
FOR
MX-ONE
68
26/1531-ANF 901 14 Uen E10 2014-01-22
Below is an example how to set the parameters in the configuration file:
recorder address1: 192.168.1.20
recorder address2: 192.168.1.21
#recording destination1:
recording destination beep: 0
sip services transport protocol: 1
sip services port: 7300
Recorder addressN
specifies the trusted IP addresses corresponding to
the recording system.
Recording destinationN
specifies the trusted IP addresses corre-
sponding to the destination where the RTP/SRTP streams should be
sent. If these parameters are left undefined, no authentication checks
are performed. This is the case in this example.
Recording destination beep
defines if a beep shall be heard to notify that
recording is ongoing.
Sip services transport protocol.
The following options exist:
•
-1
: (default), which means that the same protocol will be used as
defined in the parameter
sip transport protocol
parameter.
•
0
: TCP/UDP
•
1
: UDP
•
2
: TCP
16.2
Configuration at Recording on Demand
The prerequisite is that the settings for active recording is done, see
section 16.1 Configuration at Total Recording on page 67.
When the user has pressed the recording key an icon is shown in the
display when the phone has got a confirmation from the recording
system that the recording has started.
The shortcut key for recording is initiated from the PBX.
The URL to the recording system that the telephone sends when the
user presses the recording key, can be defined in one of the following
ways:
•
MX-ONE command
extension_key
. The advantage is that in a
free seating environment, the recording key with the associated url
will follow the user.
•
In the configuration file for the phone. Can be used where it is not
necessary that the key follows the user.
