page 7
To program or change your latch code enter the following;
(MASTER CODE) + 5 + (LATCH CODE)
Should you make a code entry error, simply press the * key and enter the correct code. You may select any 4 digit
latch code you wish. If you receive an ERROR, you must select another code as it is already in use. The unit will
respond with a GOOD BEEP with the acceptance of the new Latch Code and you will be exited from the
program
mode.
NOTE: On gates with a timer to close the “TIMED DURATION” starts when
the latch code is released.
“0”
Sub-mode 0 (Clear memory)
!!!! WARNING ALL ACCESS CODES WILL BE DELETED !!!!
To delete all access codes from memory enter the MASTER CODE, followed by 0, and the re-enter the MASTER
CODE.
(MASTER CODE) + 0 + (MASTER CODE)
Should you make an entry error, simply press the * key and re-enter the correct data. If the second entry of the
master code is correct there will be a short pause before a GOODBEEP is heard and then the unit will automatically
be exited from the program mode. If the second entry of the master code is incorrect, the unit will still respond with
a GOODBEEP indicating that it is exiting the program mode however, there will be no pause on the GOODBEEP and
the memory will not be erased.
NOTE: It should not generally be necessary to erase all access codes from memory unless codes are forgotten
and are occupying necessary memory space. A good log and maintenance of access codes should prevent this
from ever needing to be done.
