page 4
STEP 1-MOUNTING THE UNIT
Page 3 tells you what tools and instruments you will need to install your unit and presents a parts check list. Make
sure to have all the tools listed. Upon opening the box, check off the items enclosed with the unit. If any items are
missing from your unit, contact American Access Systems immediately.
The ADV-100sg is designed to mount in a standard 2 x 4 electrical box. Two security screws are provided to prevent
tampering. American Access Systems can provide the proper tool to install these screws for a additional cost. They
are standard (snake eyes) screws.
Once you have made your connections, fold the wires into the box and secure the keypad being
careful not to pinch any wires between the box and keypad panel.
STEP 2-SYSTEM CONNECTIONS
Study the WIRING COLOR CODE chart below and then proceed to the hookup steps.
(TABLE 1)
WIRING COLOR CODES
WHITE
12 - 24 VOLTS
WHITE
AC or DC
LATCH CONTACTS
BROWN
RELAY COMMON
ORANGE
NORMALLY
OPEN
BLUE
NORMALLY CLOSED
HOOKUP STEPS
(A
).
Your DKLP control unit operates on 12 to 24 volts AC or DC. Measure the voltage from the power source to
make sure it falls within these tolerances. Locate the two white wires on the circuit board and with the power off
connect them to a constant power supply.
(B).
Connect the device to be controlled to the appropriate control leads of the ADV-100 (See above diagram).
(C).
Double Check your connections. When you are sure that everything is hooked up correctly, apply power to the
unit. A BEEP should be heard when you press a key on the keypad.
