THERMOSTAT AND TIMER REMOTE CONTROL
TRANSMITTER FUNCTIONS
Set the display (from *C/24 h to *F/12 h and vice versa)
• After connecting the battery or by simultaneously pressing
AUTO
and
TIMER,
the display flashes you
are in set mode.
• From set mode, press
AUTO
to switch from *F (and 12 hour clock) to *C (and 24 hour clock)
• The display will automatically return to manual mode after some time, but you may immediately return
ual by depressing the
TIMER
button.
Set the current time
• After connecting the battery or by simultaneously pressing
AUTO
and
TIMER
, the display flashes you
are in set mode.
• From set mode, press (
A
) to set the hour and (
B
) to set the minute.
• Wait or press
TIMER
to return to “manual” mode.
Programming the Desired Set Temperature
• Press
AUTO
until the display flashes
• Press (
A
) or (
B
) to the desired temperature.
• Wait or press
AUTO
to switch to automatic mode.
• A sensor in the remote control measures the room temperature. The controller compares the room temper-
ature with the set temperature and sends a signal to the receiver to turn the gas valve motor, which adjusts
the flame height accordingly.
Programming the Timer
• Press
TIMER
until P1* (start) flashes (period 1. heating cycle on).
• Set the time for the beginning of the first heating period by pressing (
A
) for hour and (
B
) for minute.
• Press
TIMER
again P1* disappears and the symbol P1
)
(finish) appears.
• Set the time for the end of the first heating period.
• Press
TIMER
again to set the second heating period P2* (start) and P2
)
(finish).
• Store both heating periods by pressing
TIMER
again.
NOTE!
If only one heating period is desired, programme the same time for P2* and P2
)
as for P1* and
P1
).
Aarrow Sherborne GSL CF
35
USER INSTRUCTIONS
