FIREBOX LININGS & THROAT
PLATE
The Nouveau 7 Multifuel stoves firebox has
reflective liners to the sides and rear) and a
specially shaped throat plate which sits on the
liners. If these are not in place please refer to page
17 to install these.
MULTIFUEL GRATE
The Aarrow Multifuel grate comprises of a series of
reciprocating cast iron bars seated on a pivoted
"comb". These should come fitted in your stove, if
not please refer to page 18 for fitting and operation
and also operating instructions on fuels for correct
settings of the grate.
AIR INLET CONTROLS
Nouveau multifuel stoves have two air inlets:
•The air wash system (so called because its
pre-heated high speed air washes across the inner
face of the door glass, keeping it clear), which
provides over draught, and
•The primary air inlet providing under draught to
the base of the fire chamber through the gap
between the body and the ash pit door.
PRIMARY AIR FOR MULTIFUEL
On Multifuel units primary air enters the appliance
through the gap between the body and the ash pit
door. The width of the gap is controlled by rotating
the door knob (if hot, with operating tool)
anti-clockwise to increase the the air inlet,
clockwise to reduce the air inlet, or seal the ash
door completely.
AARROW AIRWASH SYSTEM
The air wash has an internal sliding plate with slots,
housed in a cover plate, and is located above the fire
door. Sliding the control knob to the right as far as it
will go achieves the fully open position. Sliding it to
the left will shut off the air inlet slots As shown in
Fig. 1 and Fig. 2.
Fig. 1 Fully Closed Fig. 2 Fully Open
Note: Opening or part opening of the ash door is
controlled by the "interlock" device located in the
front of the unit (refer to INTERLOCK section on
page 9).
Even when all the slots are completely shut a
"bleed" of secondary air will be maintained
ensuring that inflammable gases are burnt off.
DISASSEMBLE AIRWASH
The Nouveau air wash may be disassembled for
cleaning or adjustment. To achieve this, the
following procedure should be followed:
This should only be carried out when the fire is cold
and unlit.
•Support Air Wash cover with one hand
•Move cover up by smartly tapping the bottom with
a hammer. (Fig. 3)
•Remove assembly from appliance.
•Clean and/or adjust.
•Refit using reverse procedure.
Fig. 3 Disassembling Airwash
8
Nouveau 7 Multifuel Stoves
OPERATING INSTRUCTIONS