4 TONNE
2 Post Base Plate Lift
OPERATING INSTRUCTIONS
The lift should only be operated by personnel that have
been thoroughly trained in operation and maintenance of
the lift.
1.
Position the vehicle between the columns, turn off the
engine and apply the park brake.
2.
Adjust the lifting arms until they reach the supporting
position of the vehicle.
Note: It is important that the vehicle is evenly balanced on
the lift.
3.
Make sure that all personnel are clear and there are no
obstructions around the lift.
TO RAISE THE LIFT
1.
Press the “UP” button on the control box.
2.
Raise the lift to approximately 500mm, stop and check that
the lifting pads are evenly supporting the lifting positions of
the vehicle.
3.
Continue raising the lift to the desired working height
checking for any obstructions.
Once the lift has reached the desired working height lower
the lift onto the safety locks by means of pressing the lock
lowering button on the control box.
Note: Check for correct engagement on the locks.
TO LOWER THE LIFT
1.
Check for any obstructions under the lift prior to lowering
the lift
2.
Press the “DOWN” button on the control panel until the
locks are clear
Please note: the lift will raise approximately 100mm and
then will descend automatically.
3.
Once the lift has reached its lowest position, swing the arms
back into their rest position
4.
Turn the power switch to the off position on the control
panel.
Design Code: AS1418.9 -1996
MODEL:
AL-9000DS-D
SERIAL NO.:
APPROVALS:
WAH21203
Summary of Contents for AutoLift AL-900DD
Page 9: ...4 2 Parts list 9 ...
Page 10: ...10 ...
Page 11: ...4 3 Hydraulic unit 11 ...
