UP
Turn on the power switch
The lift is raised
Press the UP button
Motor
will
drive the gear pump
Cylinder
s will raise the platforms
DOWN
Turn on the power switch
Press the DOWN button
The lift
will raise then
automatically
lower
Press the DOWN button
4.3 Flow chart for operation
4.4 Operation instructions
Raise the hoist
1.Make sure that you have read and understood the operation manual before operation.
2.Drive and park the vehicle
evenly
on
two platforms.
3.Place the four rubber pads under the
jacking points
of the vehicle a
s per the car manufacturers recommendations
.
4.Press
and hold
the UP button on the control box until rubber pads have touched t
he underside
of
the
vehicle.
5.
Press the
UP button
to approx. 500mm or until the vehicle wheels leave the ground. C
heck
that the rubber blocks are
position
ed correctly under the vehicle
.
6.
Continue to
raise the vehicle to the
desired
height,
make sure the safety locks are correctly engaged. Turn off
the
“Emergency stop” button
.
Lower the hoist
1. Switch on (press the “emergency stop button” until the power indicator is on).
2.Press the DOWN button to lower the hoist.
Note:
the hoist will
automaticaly raise to release the locks, then will lower.
3.
When the hoist has been lowered to its lowest position, remove the rubber blocks and if nessary fold down the run up ramps.
4.5 Emergency lowering in case of no power
The safety lock is not engaged :
a.
Tie
back the safety mechanism with means of a cable tie or similar.
9
