AAQ AL-4000A, Installation Manual & Operation Instructions, Page: 12 / 37

INSTALLATION
Please ensure that the hoist is installed in compliance to relevant state
requirements regarding positioning in the workshop.
Installation must be performed by Competent Personnel Only.
The Hoist must be installed in a suitable environment for the safe repair
of motor vehicles.
Foundation
The hoist must be bolted to level concrete that is in good condition. Do not
install the hoist on or near cracks and expansion joints in the concrete, doing
this could effect the safe installation of the hoist.
The concrete must:

Have a minimum thickness of 1
25
mm

Be Reinforced

Be a grade of no less than 25MPA.
Tools Required
For the installation of the hoist you will require the following:

Rotary hammer drill

16mm Masonry drill bit

Chalk line

Spirit Level

General tool Kit
Unpacking
The hoist is supplied in a purpose built cradle. Once unpacked, the following
will be included:

2 Platforms

2 Transverse Beams

1 Control Post

3 Non-Control Posts

4 Safety Ladders

2 Run-Ups

2 Wheel Stops

Fitting Kit

2 Jacking Bridges (If Supplied)
11