CommLink 5 Technical Guide
PRISM 2 SETUP
11
Prism 2 Setup Instructions
12. Th
e
Search for Installed Units Window
will pop up.
Click
<Start Search>
located in the upper left -hand corner
of the window to initiate an automatic detection of all
installed controllers on your system.
13.
If everything is working correctly,
Units Found on this
Loop
should increase. You will also see green boxes
indicating units that have been found.
.
14. If
Units Found on this Loop
stays at zero, check the
wiring to the CommLink 5 and the AHU/RTU Control-
lers and/or read through these directions again to make
sure all steps were followed.
15. To stop a search,
click
<Cancel Search>
.
16. Once you are done searching for units,
close
out of the
window or
click
<Exit>
.
17. A window will pop up that asks, “Do you want to save
the search results?”
Click
<Yes>
if you wish to save the
results.
Click
<No>
if not.
18. You can now access any installed unit from the
Main Prism
2 Screen
by selecting a loop from the
Loop Selection
Window
with a
single-click
and by selecting the unit from
the
Unit Selection Window
with a
double-click
.