Aanderaa DCPS 5400, Operating Manual

Page: 63 / 150

July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor Page 63
Refer to
Figure 3-5
: AADI Real-Time
Collector uses a default setting that fits
for most Smart Sensor. However the
DCPS sensor outputs a large amount of
data and might have much longer
response time (depending on the
configuration) than other smart sensors.
Some of the connection settings might
need to be changed. We recommend
using the settings as shown in
Figure
3-5
.
After updating the Advanced
Connection Settings , click on Apply
and OK and then OK to go back to the
start screen.
Figure 3-5: Advanced connection setting
Press Open Port and the connection to
the SeaGuardII/SmartGuard should be
established within a few seconds and
the status turn to green. After power up
it will take approximately 30 seconds
before the logger is ready.
Open
Control Panel in the lower right
corner (refer
Figure 3-7
).
Figure 3-6: AADI Real-Time Collector main menu
3.3.4
Control Panel
In the Control Panel window you will find four tabs, Recorder Panel, Device Configuration Device Layout and
System Status . Under Recorder Panel you can start and stop recordings. If the recorder is running first click on the
Stop Recorder as you are not allowed to configure the sensor when recording. For information about Device Layout
and System Status see Manual for SeaGuardII Platform TD303 or SmartGuard TD293.