4
Gear
Crank
FIG. 4
Remote
Switch
EXTEND
RETRACT
Fig. 5
Important:
The Black and White wires extending
through the end cap are not used for this installation.
Cut wires off flush with end cap and throw away.
8. Choose a desired location for the remote switch inside
the living quarters such as the door area. Avoid areas
where switch may be exposed to weather.
9. Cut hole in structure where remote switch is to be
installed. Place decal on bezel and pop switch into
opening. Secure bezel with appropriate fasteners (not
supplied).
10. Route a Brown, Yellow and Green wire from the
remote switch to the control box. Install 1/4" insulated
terminals on remote switch end of wires. Use the
supplied pig tail to connect the switch to the Brown/
White, Yellow/White and Green/White wires at the
control box.
Important:
Dielectric grease must be placed
3 on all exposed pins.
1
1. Run two (2) wires from the control box to the 12 VDC
supply source. It is recommended that these wires be
(Red+ and Black -) 12 gauge wires. This should be on
a separate 15 amp circuit. Connect the Red and
Black wires from the control box to the 12VDC supply
wires using butt connectors.
12. To ensure proper operation, the control box must have
a minimum of 12.5 VDC at the control box during
awning operation. It may be necessary to increase the
wire size if voltage is below 12.5 VDC.
13. Auto Interlock Connection
A. Run a 16 gauge wire (installer supplied) from the
ignition Switch (+ 12 VDC when key is on) of
vehicle to the Ignition Interlock (Pink) wire of
control box.
B. Connect wires using supplied pigtail. See FIG. 7
and FIG. 7A.
D.OTHER INSTALLATION NOTES
1. To prevent water leakage, always use silicon sealant
where each fastener enters the sidewall of the vehicle.
2. Do not over tighten fasteners. This will cause them to
"strip out" and severly weaken their holding ability.
OPERATING INSTRUCTIONS
A.TO OPEN
1.
Oasis
(Manual)
a. Place the hook of the crank into the eye of the gear
and turn gear counter-clockwise to unroll the
awning. (See FIG.4).
2.
Oasis/Elite
(Electric)
a. Press and hold the remote switch in the extend
position until the awning is fully open. Release
switch to prevent awning from rolling up back-
wards. See FIG.5.
b. Awning can also be opened manually by using the
crank without using the switch. See FIG. 4.
