A&D UA-705, Instruction Manual

Page: 7 / 14

English 6
Using The Monitor
Attaching The Arm Cuff
1. Wrap the cuff around the upper arm,
about 2 - 3 cm above the elbow, as
shown. Place the cuff directly against
the skin, as clothing may cause a faint
pulse and result in a measurement
error.
2. Constriction of the upper arm, caused
by rolling up a shirtsleeve, may prevent
accurate readings.
3. Confirm that the index points within
the proper fit range.
How To Take Proper Measurements
For the most accurate blood pressure
measurement:
Sit comfortably at a table.
Rest your arm on the table.
Relax for about five to ten minutes
before measurement.
Place the center of the cuff at the same height as your heart.
Remain still and keep quiet during measurement.
Do not measure right after physical exercise or a bath. Rest for twenty or
thirty minutes before taking the measurement.
Try to measure your blood pressure at the same time every day.
Measurement (Operation)
During measurement, it is normal for the cuff to feel very tight.
Select a measurement mode (operation of the device).
Normal measurement with storing data :
.....................................
Press the
START
button.
Recalling data :
.........................................
Press and hold the
START
button to recall data.
Clearing data :
........................................................................
Remove the battery and re-install it.
After Measurement
After the measurement is completed, remove the cuff and record your data,
then press the
START
button to turn off the power.
Note: The device is an automatic power shut-off function, which turns the power
off approximately one minute after measurement.
Allow at least three minutes between measurements on the same person.
Rolled up shirtsleeve
2 -3 cm
Constriction of the Upper Arm
Air Hose
Cuff
Index and Proper fit range