A&D UA-1200BLE, Instruction Manual

Page: 21 / 172

English 19
Measurements
Visitor Mode Measurement
1. Press the START button on the monitor.
2. Press the START button again to switch between username and select “0
Visitor”.
3. Measurement starts automatically after 3 seconds.
4. When the measurement is complete, the monitor
will display results similar to the icon on the right.
(Systolic, diastolic and pulse rate will be
displayed in rotation.)
Visitor Mode is only available through the monitor. Data is not stored in
visitor mode.
Notes for Accurate Measurement
Sit down in a comfortable position. Place your arm on a table with your
palm facing upward and the cuff at the same level as your heart.
Relax for about five or ten minutes before taking a measurement. If you
are excited or depressed by emotional stress, the measurement will
reflect this stress as a higher (or lower) than normal blood pressure
reading and the pulse reading will usually be faster than normal.
An individual's blood pressure varies constantly, depending on what you
are doing and what you have eaten. What you drink can have a very
strong and rapid effect on your blood pressure.
This device bases its measurements on the heartbeat. If you have a very
weak or irregular heartbeat, the device may have difficulty determining
your blood pressure.
Should the device detect a condition that is abnormal, it will stop the
measurement and display an error symbol. See page 8 for the
description of the symbols.
This blood pressure monitor is intended for use by adults. Consult with
your physician before using this device on a child. A child should not use
this device unattended.
This automatic blood pressure monitor’s performance may be affected by
excessive temperature or humidity, or altitude.