18
Continued
SpO
2
value
•
Updates the value during measurement.
•
Displays " - - - " during pulse detection, and "LF"
when the sensor is not connected.
SpO
2
value
(When an alarm occurs)
•
Flashes in red when the limit values are exceeded.
•
Retained until the value is within the limit values.
"%"
•
Displayed as the unit of SpO
2
.
5 SpO
2
display
" " (Red circle)
•
Displays a red circle near "SpO
2
" when the limit
values are set.
6
ECG waveform
display
ECG waveform
•
Displays the ECG waveform in the preset sweep
rate.
•
Not available for TM-2560G/TM-2560GP.
7
Plethysmograph
display
Plethysmograph
•
Displays the SpO
2
plethysmograph in the preset
ECG sweep rate.
•
Two displays for TM-2560G/TM-2560GP. (The
sweep rate is fixed to 25 mm/s.)
8 Patient
display
Patient to measure
blood pressure
•
Displays "ADULT" to indicate that the patient whose
blood pressure to be measured is adult.
Interval to measure
blood pressure
•
Displays the preset blood pressure measuring
interval.
9
Measuring
interval display
"CYCLE"
•
Displayed to indicate that the blood pressure
measuring interval is displayed.
10
Measuring time
display
Blood pressure
measuring time
•
Displays the time the blood pressure is measured.
11
Blood pressure
unit display
Blood pressure unit
•
Displays "mmHg" as the unit of blood pressure.
12 Error
message
Blood pressure
measurement error
•
Displays the error that occurs during blood
pressure measurement.
13
ECG lead
display
ECG lead
•
Displays the preset lead type as "l", "ll", or "lll".
14
ECG displaying
magnification
display
ECG displaying
magnification
•
Displays the preset ECG displaying magnification.
15 Alarm off mark
Alarm off mark
•
Illuminates when the ALARM OFF key is pressed to
stop the alarm.
16
Current time
display
Current time
•
Displays the current time.
17
Power supply
display
Power supply
•
Displays the power currently used.
•
Displays the remaining battery charge when the
battery is used. (Refer to "6-12 Power Supply".)
Temperature probe ID
•
Displays the preset temperature probe ID as "T-
∗∗
".
Temperature value
•
Updates during measurement using the
temperature probe.
•
Displays " - - - " when communication with the
probe is disconnected.
Antenna mark
•
Displays the communication status by the number
of antennas.
Temperature value
(When an alarm occurs)
•
Flashes in red when the limit values are exceeded.
•
Retained until the value is within the limit values.
"°C "
•
Displayed as the unit of temperature.
18
Temperature
display
" " (Red circle)
•
Displays a red circle near temperature probe
display when the limit values are set.
