![background image](http://html1.mh-extra.com/html/aandd/ra3100-omniace/ra3100-omniace_simple-instruction-manual_446281036.webp)
4.Configuring Measurement - 4.3.Recording Setup
36
1WMPD4004445
T0
T1
T2
T3
T4
T5
T6
T7
T8
T9
Sampling data
Sampling period
Time
If the input signal is too fast for the sampling period, the waveform reproducibility may drop and lead to
the unexpected loss of pulses. Raising the sampling speed improves the waveform reproducibility but
increases the recorded data.
P-P Sampling
P-P sampling performs sampling with the data within the sampling period as the fastest sampling (20
MS/s), to detect the peak values (maximum value and minimum value) and record those peak values as
the recorded data.
This data format is suitable for the waveform playback of long-term recording, as it enables waveform
reproducibility of a wide band of data, without sudden spike noise, etc.
A disadvantage is that it cannot perform data analysis after recording (average, RMS, FFT, etc.)
4.3.4. Relationship between Sampling Speed and Chart Speed
The relationship between the sampling speed of this product and the chart speed of a conventional
chart recorder is indicated in the table below.
Sampling Speed
Chart speed
100 ms/div
(1 kS/s)
100 mm/s
200 ms/div (500 S/s)
50 mm/s
500 ms/div (200 S/s)
20 mm/s
1 s/div
(100 S/s)
10 mm/s
2 s/div
(50 S/s)
5 mm/s
5 s/div
(20 S/s)
2 mm/s
10 s/div
(10 S/s)
1 mm/s
20 s/div
(5 S/s)
30 mm/min
50 s/div
(2 S/s)
12 mm/min
100 s/div
(1 S/s)
6 mm/min
2 min/div
(50 S/min)
5 mm/min
5 min/div
(20 S/min)
2 mm/min
10 min/div
(10 S/min)
1 mm/min
T0
T1
T2
T3
T4
T5
T6
T7
T8
T9
Time
Sampling period
P-P data