A&D AD-1191, Instruction Manual

Page: 15 / 34

10 10 10 10 10
With the printer in the setup menu and with
CONFIGURE [NEXT/OK] CONFIGURE [NEXT/OK]
CONFIGURE [NEXT/OK] CONFIGURE [NEXT/OK]
CONFIGURE [NEXT/OK] as the last item printed, press
OK OK
OK OK OK (right side) to access the CONFIGURE
CONFIGURE
CONFIGURE CONFIGURE CONFIGURE menu. The
following is printed:
LLLLLOAD DEF OAD DEF OAD DEF OAD DEF OAD DEFAUL AUL AUL AUL AULTS TS TS TS TS gives you the opportunity to reset the
printer to all default settings (shown below).
Choose OK OK
OK OK
OK to do this or NEXT NEXT
NEXT NEXT
NEXT to go to the next param-
eter. The following is printed:
Baud rate is the next parameter you can set in the
CONFIGURE
CONFIGURE
CONFIGURE CONFIGURE
CONFIGURE menu. The complete list of parameters and
their possible values is shown below.
The sample list above shows the current baud rate is
2400. To accept this, press
OK OK OK OK OK (right side) or view the
next baud rate value by pressing NEXT NEXT NEXT NEXT NEXT (left side). Press
OK when the baud rate you want is displayed
.
Choose from these baud rates;
300, 600, 1200, 2400, 4800, 9600, or 19200
D D
D D DA
A
A A ATTTTTA BITS
A BITS
A BITS A BITS A BITS is the next parameter. Choose the data bit
value the same way baud rate was chosen. Choices are 7
or 8 data bits.
Baud Rate Baud Rate Baud Rate Baud Rate Baud Rate
Data Bits Data Bits
Data Bits Data Bits
Data Bits
Load Defaults Load Defaults
Load Defaults Load Defaults
Load Defaults
The complete list
of defaults is
shown in the
Default Table at the
end of this manual.