Operators and Maintenance Manual
Display
EEM MOT 01 FE01.07
Page
7/16
Copyright:
Auto & Aero Technologies Sp. z o.o.
Mazowiecka 10/5, 20-723 Lublin, Poland
■
email: [email protected]
■
www.aatech.pl
The EEM MOT 01 display is connected to the system by in-built MOLEX
Ultra-Fit 3.5 mm 6 pin male connector located at the back of the
instrument. A schematic diagram of the connection is shown in Figure 4
and in Table 1.
The power supply (pins no. 5 and 6) requires 0.5 mm
2
wires.
Data bus (pins no. 3 and 4) requires twisted pair wires (2 x 0.5mm
2
)
according to DIN VDE 0814 (Fig. 4). Twisting should continue to the pins of
the connector.
Pins 1 and 2 are to be left unconnected.
Tab. 1. Connector pin assingment and pin insertion view
Pin number
Function
Connector schematic
1
Reserved (do
not connect)
2
Reserved (do
not connect)
3
RS A
4
RS B
5
GND
6
+12 V
Fig. 4. Wire twisting and connection
