INSTALLATION
Preparation and Operation
1. Check that the drain hose is correctly installed (and has not fallen out of its inlet)
2. Connect the water inlet hose and turn on the tap.
3. Insert the power plug in the socket and turn on.
4. Select water level according to the size of the load (refer page 9)
5. Select the wash mode (as per you specific model - see below)
6. Add detergent, close the list & press START/PAUSE to start the load.
3kg Model With Hot Wash Option
Program Selection
To select a desired wash program, press the
WASH
MODE
button repeatedly. This will allow you to select
combinations of
WASH,
RINSE
&
SPIN
(full cold cycle), or
(full hot cycle), or
WASH
only,
HOT WASH
or
WASH
&
RINSE,
or
RINSE
&
SPIN,
or
SPIN
only.
The Hot Wash function heats cold water supplied to the machine to a temperature of between 35ºC and
40ºC. This heating process can take up to 60 minutes (depending on the temperature of the water supplied
to the machine) - during which time the machine will gently circulate the water every 15 minutes. In
practice, the heating time usually takes 20-40 minutes in warmer weather.
The “HEATING” LED will flash while the water is heating.
Wash Time Remaining Display
The wash time will initially be displayed as 90 minutes on the LCD display and as the water is heated, it
will count down from there. As soon as the water is up to temperature, the HEATING LED will stop
flashing and the wash time will be adjusted to show the remaining actual wash cycle time.
Hot Wash Load Size
Please note that Hot Wash is only available for smaller washing loads (up to 2kg) and the LOW water mode
will automatically be selected when Hot Wash is selected. The high water level is not available for the HOT
WASH cycle.
2.5kg Model
Program Selection
To select a desired wash program, press the
WASH
MODE
button repeatedly. This will allow you to select
combinations of
WASH,
RINSE
&
SPIN
(full cycle), or
WASH &
RINSE,
or
RINSE
&
SPIN,
or
WASH
only,
RINSE
only,
SPIN
only or
QUICK
WASH.
For 2.5kg & 3kg Models
After the cycle has started, if you want to change the WASH MODE or or WATER LEVEL, please press the
START/PAUSE button, re-set your desired mode, then press the START/PAUSE again to start the new
cycle.
Pre-wash for extra soiled clothes.
For seriously stained or dirty clothes, run the RINSE/SPIN cycle to perform a pre-wash, then add laundry
detergent and select a full WASH/RINSE/SPIN cycle to complete washing.
10
Installation Notes
(cont’d)
