ERROR CODES & FUNCTIONS
ERROR CODES & SUGGESTED SOUTIONS
ERROR CODE
FAULT SYMPTOM
SUGGESTED SOLUTION
- Check that the water tap is on
- Check mains pressure or water pump operation
- Check the water inlet filter
After following the steps above, open and close
the lid to reset the washing machine
If the error persists, please call Camec.
- Ensure the lid is completely closed and/or its
hinge(s) are not broken.
If the error persists, the error could be related to
a faulty lid magnet senser or faulty PCB.
Please call Camec for further advice.
- Ensure that the washing machine is level & stable,
adjust if required
- If the clothes are uneven, adjust the distribution
of the load
After following the steps above, open and close
the lid to reset the washing machine
If the error persists, please call Camec.
- Ensure the drain hose bend is no higher than
100mm from ground level
- Do not cover the end of the drain pipe, it MUST
drain freely
After following the steps above, open and close
the lid to reset the washing machine
If the error persists, please call Camec.
- Potential faulty water level sensor alarm or
faulty level sensor connection hose
- Potential PCB fault
Please the Camec warranty department for advice
and spare part supply.
Drainage alarm
LCD displays flashing
"E4" error
LCD displays flashing
"E2" error
Lid open alert
LCD displays flashing
"F1" error
Water level alarm
LCD displays flashing
"E1" error
No water fill alert
LCD displays flashing
"E3" error
Out of balance alarm
