9
11. Check the seals for damages and if necessary
replace them.
Refit the seals and the ball and captive – if previ
-
ously removed. Grease the O-rings with a suitable
lubricating grease as used for dispensing taps.
12. Push the piston into the body of the dispense head
and reassemble. Install the CO²-seal.
Pull the knurled screw laterally out of the grip as far
as it will go. Pull the latch to the grip and hold it.
Push the grip over the flats on the piston, insert the
screw through the hole in the dispense head body
and screw it in on the other side of the grip.
10. Brush the bodies S-type and Draft as well as the
corresponding pistons with the cleaning brush (arti-
cle-no. 550396). Brush the bodies A-type, G-type and
combi as well as the corresponding pistons with the
cleaning brush (article-no. 550395). Rinse all compo-
nents with clean water.
