Aaeon EMB-LN9T Rev.B, Manual

Page: 32 / 53

M i n i - I T X E M B - L N 9 T R e v . B
3.1 System Test and Initialization
These routines test and initialize board hardware. If the routines
encounter an error during the tests, you will either hear a few short
beeps or see an error message on the screen. There are two kinds
of errors: fatal and non-fatal. The system can usually continue the
boot up sequence with non-fatal errors.
System configuration verification
These routines check the current system configuration against the
values stored in the CMOS memory. If they do not match, the
program outputs an error message. You will then need to run the
BIOS setup program to set the configuration information in memory.
There are three situations in which you will need to change the
CMOS settings:
1. You are starting your system for the first time
2. You have changed the hardware attached to your system
3. The CMOS memory has lost power and the configuration
information has been erased.
The EMB-LN9T Rev.B CMOS memory has an integral lithium
battery backup for data retention. However, you will need to replace
the complete unit when it runs down.
Chapter 3 AMI BIOS Setup 3-2