2. Check batteries to make sure that they are new alkaline or lithium AA
batteries.
3. Make sure that the camera power switch is in the “On” position and not in
the “Off” or “Test” modes.
4. Please format the SD card with AG-690HD hunting camera before
using or when camera stops taking images.
Photos Do Not Capture Subject of Interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting. For warm
environmental conditions, set the Sensor Level to “High” and for cold weather
use, set the sensor for “Low”.
2. Try to set your camera up in an area where there is not a heat source in the
camera’s line of sight.
3. In some cases, set the camera near water will make the camera take images
with no subject in them. Try aiming the camera over ground.
4. Try to avoid setting the camera up on small trees that are prone to being
moved by strong winds.
5. Remove any limbs which are right in front of the camera lens.
4.7) Firmware Upgrades
AG-690 series camera are equipped with an automatic upgrade function for
you, Upgrading is needed when an improved firmware is available. Follow
the steps to implement the upgrades.
Ø
Back up the content on the SD card on your computer (Format the
SD card if content is not useful for you)
Ø
Retrieve the SD card and plug it in your computer (SD card reader
may needed). Copy and paste the
FW18NA.BIN
file in the root
directory of the SD card. (Consult with the Local distributor if there is
an upgrade available and where to download it.)
Ø
Retrieve the SD card and insert it back in the camera. Switch to
TEST mode and check the Fimrware version number in Camera
setup. If the Version number is changed, it means the updating is
successed, if not, please upgrade again.
Ø
After upgrade is done, please remember to Delete the firmware
(
FW18NA.BIN
) in SD Card otherwise, the camera will be upgrade
everytime when turn on.