Tools needed:
• 7/16 Wrench
• 1/2 Wrench
• Rubber Mallet or Hammer
• #2 Square Drive Screwdriver
or Power Drill ∕ Driver
Package Contents
NOTE:
Do not tighten any bolts
until step 4 is completed.
1 - Seat (A)
2 - Base Crosspiece (G)
4 - Glider Bearing (O)
1 - Back (B)
-
style may vary
1 - Left Arm (C) 1 - Right Arm (D)
1 - Right Base Leg (E) 1 - Left Base Leg (F)
Glider Assembly Instructions
Package contents continued on inside.
Step 7
Step 9
Step 8
Slide a washer (L) onto each bolt on the inside of
the leg.
Set the base into place. MAKE SURE YOU DON’T PUT
IT ON BACKWARDS. (See step 5, fig. A and fig. B.)
Now insert a
5
⁄
16
"
bolt through the hole in the base,
this time with the threads pointing out (heads facing
in). Slide a washer (L) onto the bolt, and then attach
it to the glider bearing (O) with a lock nut (M). Repeat
on all four corners.
Now tighten ALL your bolts, and your glider is
complete. Enjoy!
Slide a glider bearing (O) onto each bolt. Make sure it
is turned the way it shows in the above picture. Now,
turn a lock nut (M) loosely on each bolt.
NOTE: Now make sure all the bolts have been tight-
ened before continuing to Step 9.
