Step 1
Step 2
Lay seat (A) on a flat surface and slide back (B)
into seat as shown.
Tap bolts (H) into holes as shown with the heads
pointing toward the outside. Repeat on other end
and centers.
NOTE: Amount of centers may vary.
Step 3
Turn flange nuts (I) loosely onto the bolts.
NOTE: Do not tighten them until step 4 is completed.
Step 4
Step 6
Attach right arm (C) with two
¼"
long bolts (J)
through legs, and one
¼"
short bolt (H) through
arm and turn flange nuts (I) loosely onto the bolts.
Repeat on other end with left arm (D).
NOTE: You may have to push up or down, forward or
backward, on the back or arm assembly to line up
the bolt holes.
Turn the whole seat assembly upside down, and
insert a
5
⁄
16
"
bolt (K) into each leg with the threads
pointing in toward center (heads facing out). Use a
rubber mallet and drive the square nibs of the bolt
firmly into the material to prevent the bolt from
spinning when you tighten the nut.
Step 5
To assemble the glider base, you have to attach
the base crosspieces (G) to the base legs (E) and (F)
using 1¾" screws (N)
NOTE the difference in the front and the back of the
base as shown in figure (A) and figure (B) below.
See the difference in the length of
fig. A and fig. B at the arrow.
Package Contents
Continued from front page
Hardware Package
4 - ¼
"
Long Bolt (J)
10 - ¼
"
Short Bolt (H)
8 -
5
⁄
16
"
Bolt (K)
12 - 1¾
"
Screw (N)
1 - Bit (P)
8 -
5
⁄
16
" Locknut (M)
8 -
5
⁄
16
"Washer (L)
14 - ¼" Flange Nut (I)
Short
Bolt (H)
Short
Bolt (H)
Long
Bolt (J)
Long
Bolt (J)
fig. A
Front Side
fig. B
Back Side
