I
NSTALLATION DIAGRAM
S
tarting on the driver side front of the vehicle, remove the existing factory bolts of the lower hole, (if equipped) on the
side panel located by the front tire opening. ( See Figure 1 )
Remove the two factory bolts, (if equipped), along the side panel of the threaded holes to mount the center Bracket,
and the very last two factory bolts, (if equipped), along the side panel to mount the rear Bracket. ( See Figure 2 )
Align the holes on the bottom of the Side Bar with the holes on the Mounting Brackets. Attach the Side Bar to the
Mounting Brackets with the hex head bolts, Spring Washers, Washers. Do not tighten at this time. ( Installation
location refers to the below figure )
S
TEP 1
S
TEP 2
L
evel and adjust Side Bar properly and tighten all hardware. Repeat Steps 1-2 for passenger Sidebar. Do periodic
inspections to the installation to make sure that all hardware is secure and tight.
*
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective
layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
S
TEP 3
Remove this
factory bolt
Installed on the threaded
hole in front of the vehicle
Only one hole
Two holes
Installed on the threaded
holes in middle & rear of
the vehicle
Remove the two
factory bolts
F
IGURE 2
F
IGURE 1
FRONT OF THE
VEHICLE
MIDDLE AND REAR
OF THE VEHICLE
Assembly
hex head bolts,
Spring Washers, Washers.
Connect the
Step Rail
to the
bottom of the vehicle
I
NSTRUCTION MANUAL
AAPRODUCTS INC.
F
or Technical Support Call:1-888-806- 3972 / 626-332-4245
